tunnel mode ipv6ip
Configures the tunnel mode as a manual IPv6 tunnel.
Command Default
A tunnel is not configured.
Modes
Interface tunnel configuration mode
Usage Guidelines
You can use a manually configured tunnel to connect two isolated IPv6 domains. You should deploy this point-to-point tunneling mechanism if you need a permanent and stable connection.
ICX 7150 and ICX 8100 devices do not support tunnels.
The
no form of the command removes the configured tunnel mode.
Examples
The following example configures the tunnel mode as a manual IPv6 tunnel.
device# configure terminal device(config)# interface tunnel 1 device(config-tnif-1)# tunnel source ethernet 1/1/1 device(config-tnif-1)# tunnel destination 10.162.100.1 device(config-tnif-1)# tunnel mode ipv6ip device(config-tnif-1)# ipv6 enable