member-vlan

Adds members to the VLAN topology group.
Syntax
member-vlan vlan-id [ to vlan-id | [ vlan-id to vlan-id | vlan-id]... ]
no member-vlan vlan-id [ to vlan-id | [ vlan-id to vlan-id | vlan-id]... ]
Command Default

Member VLANs are not added to the VLAN topology group.

Parameters
vlan-id
Adds a member VLAN ID to the topology group.
to vlan-id
Adds the range of member VLANs to the topology group.
Modes

Topology group configuration mode

Usage Guidelines

The member VLAN group must configured before adding it to the topology group.

Each topology group can control up to 4096 VLANs. The VLANs within a VLAN group have the same ports and use the same values for other VLAN parameters.

Once you add a VLAN as a member of a topology group, all the Layer 2 protocol configuration information for the VLAN is deleted. For example, if STP is configured on a VLAN and you add the VLAN to a topology group, the STP configuration is removed from the VLAN. Once you add the VLAN to a topology group, the VLAN uses the Layer 2 protocol settings of the master VLAN. If you remove a member VLAN from a topology group, you must reconfigure the Layer 2 protocol information in the VLAN or VLAN group.

The no form of the command removes the member VLANs from the topology group.

Examples

The following example adds the members to the VLAN topology group. 

device(config)# topology-group 2
device(config-topo-group-2)# member-vlan 4
device(config-topo-group-2)# member-vlan 5
Parent topic: Commands M