ip rip route-map

Applies a pre-configured route map to a RIP interface.
Syntax
ip rip route-map name { in | out }
no ip rip route-map
Parameters
name
Specifies the route-map to be applied.
in
Applies the route-map as an inbound filter; that is, it applies to routes learned from RIP neighbors.
out
Applies the route-map as an outbound filter; that is, it applies to routes advertised to RIP neighbors.
Modes

Interface configuration mode

Usage Guidelines

The no form of the command removes the route-map from the interface.

An access control list (ACL) or a prefix list can be applied as a route-map using this command.

Examples

The following command applies the route-map named map1 to filter RIP routes learned on Ethernet interface 1/1/2. 

device# configure terminal
device(config)# interface ethernet 1/1/2
device(config-if-e1000-1/1/2)# ip rip route-map map1 in
Parent topic: Commands I