system-max ip-static-arp

Configures the maximum number of static Address Resolution Protocol (ARP) table entries.
Syntax
system-max ip-static-arp number
no system-max ip-static-arp number
Parameters
number
Specifies the number of entries the static ARP table can hold.
Modes

Global configuration mode

Usage Guidelines

You must save the configuration to the startup configuration file and reload the software after changing the static ARP table size to place the change into effect.

This command configures the maximum number of static ARP entries that can be configured. When increasing static ARP table size, you must ensure that the ARP table size is also increased. For example, if you configure the maximum number of static ARP table entries to 1000, you must configure the maximum number of ARP entries to be greater than 1000. Refer to the system-max ip-arp command for more information.

When the maximum number of ARP table entries is changed, the maximum number of IP cache entries set to the same value.

The following table outlines the supported static ARP table size per platform.

Supported Static ARP Table Size

Product Default Table Size Maximum Table Size
ICX 7150 64 256
ICX 7250 512 2048
ICX 7450 512 6000
ICX 7550 512 6000
ICX 7650 512 1024
ICX 7750 512 1024
ICX 7850 512 1024
ICX 8100 512 2048
ICX 8200 512 2048

The no form of the command resets the number of allowable entries in the static ARP table to the default value.

Examples

The following example increases the maximum number of static ARP table entries you can configure to 1000. 

device# configure terminal
device(config)# system-max ip-static-arp 1000
device(config)# write memory
device(config)# end
device# reload

Related commands:

system-max ip-arp
Parent topic: Commands Si - Z