neighbor send-community

Enables sending the community attribute in updates to the specified BGP neighbor.
Syntax
neighbor { ip-address | ipv6-address | peer-group-name } send-community [ both | extended | standard ]
no neighbor { ip-address | ipv6-address | peer-group-name } send-community [ both | extended | standard ]
Command Default

The device does not send community attributes.

Parameters
ip-address
Specifies the IPv4 address of the neighbor
ipv6-address
Specifies the IPv6 address of the neighbor
peer-group-name
Specifies the peer group name configured by the neighbor peer-group-name command.
both
Sends both standard and extended attributes.
extended
Sends extended attributes.
standard
Sends standard attributes.
Modes

BGP configuration mode

BGP address-family IPv6 unicast configuration mode

Usage Guidelines

When this command is entered in BGP global configuration mode, it applies only to the IPv4 address family. Use this command in BGP address-family IPv6 unicast configuration mode for BGP4+ configurations.

Examples

The following example sends standard community attributes to a neighbor. 

device# configure terminal
device(config)# router bgp
device(config-bgp-router)# neighbor 10.11.12.13 send-community standard
Parent topic: Commands N