reload
Reloads a stand-alone device, a stack, or specified stack units other than the active
controller.
Syntax
reload
[
after
duration
|
at
time
date
[
primary
|
secondary
]
]
reload
cancel
reload
[
unit-id
unit-list
]
Parameters
- after duration
- Schedules reload after the specified duration, entered in the format dd:hh:mm, where dd is the number of days; hh represents the number of hours, from 00 to 23; and mm represents minutes, from 00 to 59.
- at time date
- Schedules reload for a specific time and date. Time is entered in this format: hh:mm:ss, where hh represents hours, from 00 to 24; mm represents minutes, from 00 to 59; and ss represents seconds, from 00 to 59. The date is entered in this format: mm-dd-yy, where mm is the month (for example, 01 for January); dd is the day in the month (for example, 09); and yy is the year (for example, 17).
- unit-id unit-list
- Specifies stack units to reload. When the
unit-id is not present, the stand-alone device or the stack on which the
reloadcommand is issued is reloaded. The unit-list may contain a single ID (2), a series of IDs (2,3), a range of IDs (4-6), or a combination ( 2,3,4-6,8). Do not use spaces between entries.
Modes
Privileged EXEC mode
Usage Guidelines
Stack units can be reloaded only if they are not the active controller.
The active controller automatically reloads on stack failover to the standby controller.
If you need to reload the active controller manually, use the
stack switch-over command. When switchover occurs, you will be able to load the former active controller
with the
reload
unit-id
command.
History
| Release version | Command history |
|---|---|
| 08.0.00a | This command was introduced. |