ip route bfd holdover-interval

Configures the time interval for which the BFD session state is not conveyed to the static route application after the BFD session goes down. During this time period, the static route is not withdrawn from the route table manager (RTM).
Syntax
ip route bfd holdover-intervaltime
no ip route bfd holdover-intervaltime
Command Default

No holdover interval is configured.

Parameters
time
Specifies the BFD holdover interval in seconds. Valid values range from 3 through 150.
Modes

Global configuration mode

Usage Guidelines

If the holdover timer is configured, an IP static route does not immediately bring down a BFD session when it is notified that a BFD session has transitioned from up to down. The IP static route waits until the period of time configured for the holdover timer has expired. If BFD declares a session up before the configured period of time expires, no action is taken.

This command is supported for ICX 7850 devices only.

The no form of the command removes the configured BFD holdover interval for the IP static route and reverts to the default value of 0 so that no holdover interval is configured.

Examples

The following example sets the BFD holdover interval to 10 seconds for the IP static route. 

device# configure terminal
device(config)# ip route bfd 10.1.1.1
device(config)# ip route bfd holdover-interval 10
History
Release version Command history
08.0.90 This command was introduced.
Parent topic: Commands I