`ip rip`

Configures Routing Information Protocol at the interface level. RIP must first be enabled globally on the device.

Syntax

ip rip { v1-only | v1-compatible-v2 | v2-only }

no ip rip { v1-only | v1-compatible-v2 | v2-only }

Command Default

By default, RIP is not configured on any interface

Parameters

v1-only: Configures the interface for RIP Version.
v1-compatible-v2: Configures the interface for RIP Version 1 with RIP Version 2 compatibility.
v2-only: Configures the interface for RIP Version 2.

Modes

Interface configuration mode.

Usage Guidelines

The no form of the command disables RIP on the interface.

Before using this command, RIP must be configured globally using the router rip command.

Examples

The following example configures RIP Version 1 on Ethernet interface 1/2/3.

device# configure terminal
device(config)# interface ethernet 1/2/3
device(config-if-e01000-1/2/3)# ip rip v1-only

The following examples removes RIP configurations from the same interface.

device# configure terminal
device(config)# interface ethernet 1/2/3
device(config-if-e01000-1/2/3)# no ip rip v1-only

ip rip