show relative-utilization

Displays utilization percentages for an uplink.
Syntax
show relative-utilization num
Parameters
num
Specifies the utilization list number. Valid values range from 1 through 4.
Modes

User EXEC mode

Usage Guidelines

After you configure an uplink utilization list, you can display the list to observe the percentage of uplink bandwidth that each downlink port used during the most recent 30-second port statistics. The number of packets sent and received between the two ports is listed, as well as the ratio of each downlink port's packets relative to the total number of packets on the uplink.

Examples

The following is sample output from the show relative-utilization command. 

device> show relative-utilization 2

uplink: ethe 1/1/23 
30-sec total uplink packet count = 0
packet count ratio (%)
1/1/1:---
History
Release version Command history
09.0.00 This command was deprecated.
09.0.10c Support for this command was restored.
Parent topic: Show Commands