ipv6 mld static-group

Configures one or more physical ports to be a permanent (static) member of a multicast listening discovery (MLD) group based on the range or count.
Syntax
ipv6 mld static-groupmulticast-group-addr[countcount-number|tomulticast-group-addr][ethernetstackid/slot/portnum][ethernetstackid/slot/portnumtoethernetstackid/slot/portnum]]
no ipv6 mld static-groupmulticast-group-addr[countcount-number|tomulticast-group-addr][ethernetstackid/slot/portnum][ethernetstackid/slot/portnumtoethernetstackid/slot/portnum]]
Command Default

The port is not added to MLD group

Parameters
ip-addr
The address of the static MLD group.
countcount-number
Specifies the number of static MLD groups The range is 2 through 256.
to
Specifies a range of addresses.
ethernetstackid/slot/portnum
Specifies the ID of the physical port that will be a member of the MLD group. On standalone devices specify the interface ID in the format slot/port-id; on stacked devices you must also specify the stack ID, in the format stack-id/slot/port-id. You can configure a single port or a list of ports, separated by a space.
Modes

Interface configuration mode.

Usage Guidelines

You can specify as many port numbers as you want to include in the static group.

For a virtual routing interface (ve), specify the physical Ethernet ports on which to add the group address.

The no form of the command removes the port or ports from the MLD group.

Examples

The following example configures two static groups, starting from ff0d::1, without having to receive an MLDv1 report on a virtual Ethernet interface. 

device# configure terminal
device(config)# interface ethernet 1/1/2
device(config-if-e10000-1/1/2)# ipv6 mld static-group ff0d::1 count 2

The following example configures two static MLD groups, starting from ff0d::1, using the to keyword. 

device# configure terminal
device(config)# interface ethernet 1/1/2
device(config-if-e10000-1/1/2)# ipv6 mld static-group ff0d::1 to ff0d::2

The following example configures two static MLD groups on virtual ports starting from ff0d::1 using the count keyword. 

device# configure terminal
device(config)# interface ve 10
device(config-vif-10)# ipv6 mld static-group ff0d::1 count 2 ethernet 1/5/2

The following example configures two static groups on virtual ports starting from ff0d::1 using the to keyword. 

device# configure terminal
device(config)# interface ve 10
device(config-vif-10)# ipv6 mld static-group ff0d::1 to ff0d::2 ethernet 1/5/2
Parent topic: Commands I