show running interface

Displays information about the interface.
Syntax
show running interface [ ethernet stack/slot/port [ to ethernet stack/slot/port ] | loopback loopback-number | management por-id | tunnel tunnel-id | ve ve-number]
Parameters
ethernet stack/slot/port
Specifies the configuration on a physical interface. On standalone devices specify the interface ID in the format slot/port-id; on stacked devices you must also specify the stack ID, in the format stack-id/slot/port-id.
to
Specifies information for a range of physical interfaces.
loopback loopback-number
Specifies information for a loopback interface.
management port-id

Specifiesinformation for a management port.
tunnel tunnel-id
Specifies information for a tunnel interface.
ve ve-number
Specifies information for a virtual interface.
Modes

Privileged EXEC mode

Examples

The following example displays output from the show running interface command, showing that ACLs 10 and f10 are applied to interface 1/1/9 to control neighbor access. 

Device#show running interface ethernet 1/1/9
interface ethernet 1/1/9
 ip address 15.1.1.5 255.255.255.0
 ip pim-sparse
 ip pim neighbor-filter 10
 ip ospf area 0
 ipv6 address 201::1/64
 ipv6 ospf area 0
 ipv6 pim-sparse
 ipv6 pim neighbor-filter f10
History
Release version Command history
08.0.20a This command was modified to display neighbor filter information.
Parent topic: Show Commands