ipv6 mld access-group

Configures the Multicast Listener Discovery (MLD) report filter policy globally, for a non-defaultvirtual routing and forwarding (VRF) instance, or for an Interface.
Syntax
ipv6 mld access-group acl-name
no ip igmp access-group acl-name
Command Default

The MLD report filter policy is not configured.

Parameters
acl-name
Specifies an ACL name.
Modes

Global configuration mode

Interface subtype configuration mode

VRF configuration mode

Usage Guidelines

ACL rules are used to configure which multicast group addresses, source addresses, or report and leave messages are to be dropped or allowed. Multicast Group addresses and prefixes are configured as destination IP addresses or prefixes, and the source addresses and prefixes are configured as source IP addresses and prefixes in the extended ACL rules.

If the specified ACL is not configured, the MLD report messages for all multicast group addresses and source addresses are dropped.

If an MLD report filter policy is configured both globally and at the interface level, only the interface filter is applied.

The no form of the command disables the configured MLD report filter policy.

Examples

The following example configures the MLD report filter policy globally. 

device# configure terminal
device(config)# ipv6 mld access-group test1-v6

The following example configures the MLD report filter policy for a VE interface. 

device# configure terminal
device(config)# interface ve 10
device(config-vif-10)# ipv6 mld access-group test1-v6
History
Release version Command history
09.0.10 This command was introduced.
Parent topic: Commands I