ip pcp-remark

Enables remarking of the priority code point (PCP) field in the VLAN header for tagged packets received.
Syntax
ip pcp-remark pcp-value
no ip pcp-remark pcp-value
Command Default

PCP remarking is disabled.

Parameters
pcp-value
Specifies the PCP value ranges you are remarking.
Modes

Interface configuration mode

Usage Guidelines

The no form of this command disables PCP remarking.

In Interface configuration mode, the command enables PCP remarking for each port. The command can be configured only on Layer 2 ports. The configuration can be done on a physical port, LAG, or VE port.

Examples

The following example enables remarking of received tagged packets on a specific port when the PCP bit value is 5. 

device(config)# interface ethernet1/1/1
device(config-if-e1000-1/1/1)# ip pcp-remark 5
History
Release version Command history
08.0.95 This command was modified to remove global configuration.
Parent topic: Commands I