mvrp timer

Defines the interval at which Multiple VLAN Registration Protocol (MVRP) updates (VLAN join or VLAN leave messages) are transmitted at the system level or interface level to be used for the particular MVRP instance.
Syntax
mvrp timer join timer-value leave timer-value leave-all timer-value
no mvrp timer join timer-value leave timer-value leave-all timer-value
Command Default

The following are the default values:

  • Join timer: 200ms
  • Leave timer: 1000ms
  • Leave-all timer: 10000ms

Parameters
join timer-value
Defines the interval for the MVRP PDU transmit that makes VLAN declaration on other MVRP-enabled interfaces. Valid values range from 200 ms through 100000000 ms. The default value is 200 ms.
leave timer-value

Defines the time period an MVRP-enabled interface waits after receiving a leave message on the port to remove the port from the VLAN indicated in the leave message. If the interface receives a VLAN join message before the timer expires, the VLAN remains registered. Valid values range from 1000 ms through 100000000 ms. The default value is 100 ms. The leave timer should be greater than or equal to twice the join timer plus 600 ms.

leave-all timer-value
Defines the time interval at which a port (MVRP participant) generates LeaveAll PDUs. Valid values range from 10000 ms through 100000000 ms. The default value is 10000 ms. The leave-all timer must be comparitively greater than the leave timer value; the recommended value is at least three times the value of the leave timer.
Modes

Global configuration mode

Interface configuration mode

Usage Guidelines

All timer values must be in multiples of 10, 50, or 100 ms.

The MVRP timers must be set to the same values on all the devices that are participating in MVRP.

Interface-level timer configuration takes precedence over global timer configurations.

Ruckus recommends to maintain the default timer settings for MVRP implementation unless it is necessary to change.

The no form of the command resets the timer values to the default values.

Examples

The following example enables the MVRP timers globally. 

device# configure terminal
device(config)# mvrp timer join 300 leave 3000 leave-all 20000

The following example enables the MVRP timers on an interface. 

device# configure terminal
device(config)# interface ethernet 2/1/25
device(config-if-e1000-2/1/25)# mvrp timer join 300 leave 1500 leave-all 15000
History
Release version Command history
08.0.90 This command was introduced.
Parent topic: Commands M