show openflow interface

Displays the information about the interfaces in a OpenFlow flow.
Syntax
show openflow interface
Modes

User configuration mode

Usage Guidelines

The show openflow interface command displays the physical port, up and down links, tag status, MAC addresses, and the modes.

The show openflow interface command displays the following information:

Output field Description
Port Port Number
Link Link status
Speed Configured speed
Tag Tag status
Mac Address MAC address of the port
Mode Gives the information about the layers
Examples

The following example displays information for all OpenFlow interfaces. 

device# openflow enable layer3 hybrid
device# show openflow interface

Total number of Openflow interfaces: 5

Port  Link     Speed Tag MAC            OF-portid Name    Mode      
1/1/1   Up       1G    Yes 000c.dbf5.bd00 1                 Layer2         
1/1/2   Up       1G    Yes 000c.dbf5.bd01 2                 Layer2         
1/1/3   Up       1G    Yes 000c.dbf5.bd01 3                 Hybrid-Layer3
1/1/4   Up       1G    Yes 000c.dbf5.bd01 4                 Hybrid-Layer3
1/1/5   Up       1G    Yes 000c.dbf5.bd01 5                 Hybrid-Layer3

The following command displays information for a particular interface on a specific slot and port. 

device# show interface ethernet 1/1/6

GigabitEthernet1/1/6 is up, line protocol is up 
  Port up for 51 minutes 53 seconds 
  Hardware is GigabitEthernet, address is 748e.f8e7.d901 (bia 748e.f8e7.d901)
  Configured speed auto, actual 1Gbit, configured duplex fdx, actual fdx
  Configured mdi mode AUTO, actual MDI
  Member of L2 VLAN ID 100, port is untagged, port state is FORWARDING
  BPDU guard is Disabled, ROOT protect is Disabled, Designated protect is Disabled
  Link Error Dampening is Disabled
  STP configured to ON, priority is level0, mac-learning is enabled
  OpenFlow enabled, Openflow Index 1, Flow Type Layer2
  Flow Control is config enabled, oper enabled, negotiation disabled
  Mirror disabled, Monitor disabled
  Not member of any active trunks
  Not member of any configured trunks
  No port name
  Inter-Packet Gap (IPG) is 96 bit times
  MTU 1500 bytes, encapsulation ethernet
  300 second input rate: 3904 bits/sec, 7 packets/sec, 0.00% utilization
  300 second output rate: 0 bits/sec, 0 packets/sec, 0.00% utilization
  23153 packets input, 1530094 bytes, 0 no buffer
  Received 1721 broadcasts, 21432 multicasts, 0 unicasts
  0 input errors, 0 CRC, 0 frame, 0 ignored
  0 runts, 0 giants
  0 packets output, 0 bytes, 0 underruns
  Transmitted 0 broadcasts, 0 multicasts, 0 unicasts              
  0 output errors, 0 collisions
  Relay Agent Information option: Disabled

Egress queues:
Queue counters    Queued packets    Dropped Packets
    0                   0                   0
    1                   0                   0
    2                   0                   0
    3                   0                   0
    4                   0                   0
    5                   0                   0
    6                   0                   0
    7                   0                   0

History
Release version Command history
08.0.20 This command was introduced.
Parent topic: Show Commands