mvrp spanning-tree

Configures the Multiple VLAN Registration Protocol (MVRP) dynamic VLANs to be enabled with the Spanning Tree Protocol (STP) or Rapid Spanning Tree Protocol (RSTP).
Syntax
mvrp spanning-tree [ 802-1w ]
no mvrp spanning-tree [ 802-1w ]
Command Default

By default, all MVRP dynamic VLANs are STP-enabled.

Parameters
802-1w
Configures the MVRP dynamic VLAN to be RSTP-enabled.
Modes

Global configuration mode

Usage Guidelines

You can configure this command before MVRP is enabled on any interface, but this configuration cannot be changed when MVRP is enabled on any port.

All the MVRP-enabled ports must have the same untagged VLAN membership. Consequently, the untagged VLAN membership of MVRP-enabled ports cannot be changed during MVRP operation. Therefore, the following operations issue an error message:

  • Configuring an MVRP-enabled untagged port on a different VLAN
  • Removing an MVRP untagged VLAN
  • Enabling MVRP on a port with untagged membership of a different VLAN

The no form of the command blocks the MVRP dynamic VLANs from running spanning tree instances.

Examples

The following example configures MVRP dynamic VLANs to be RSTP-enabled. 

device# configure terminal
device(config)# mvrp spanning tree 802-1w
History
Release version Command history
08.0.95 This command was introduced.
Parent topic: Commands M