ipv6 ospf mtu-ignore
Enables or disables maximum transmission unit (MTU) match checking.
Command Default
Enabled.
Modes
Interface subtype configuration mode
Usage Guidelines
In default operation, the IP MTU on both sides of an OSPFv3 link must be the same, and a check of the MTU is performed when Hello packets are first exchanged.
The
no no form of the command disables MTU-match checking on a specific interface.
Examples
The following example disables MTU-match checking on a specific OSPFv3 Virtual Ethernet (VE) interface.
device# configure terminal device(config)# interface interface ve 1 device(config-vif-1)# no ipv6 ospf mtu-ignore
The following example enables MTU-match checking on a specific OSPFv3 Virtual Ethernet (VE) interface.
device# configure terminal device(config)# interface interface ve 1 device(config-vif-1)# ipv6 ospf mtu-ignore
History