use-v2-checksum
Enables the v2 checksum computation method for an IPv4 Virtual Router Redundancy
Protocol version 3 (VRRPv3) session.
Command Default
VRRPv3 uses the v3 checksum computation method.
Modes
VRRP configuration mode
Usage Guidelines
The
no form of this command enables the default v3 checksum computation method in VRRPv3
sessions.
Some non-Ruckus devices only use the v2 checksum computation method in VRRPv3. This command enables the v2 checksum computation method in VRRPv3 and provides interoperability with these non-Ruckus devices.
Examples
The following example shows the v2 checksum computation method enabled in IPv4 and IPv6 VRRPv3 instances.
device(config)# interface ve 3 device(config-vif-3)# ipv4 vrrp vrid 2 device(config-vif-3-vrid-2)# version v3 device(config-vif-3-vrid-2)# use-v2-checksum device(config)# interface ve 3 device(config-vif-3)# ipv6 vrrp vrid 2 device(config-vif-3-vrid-2)# use-v2-checksum
History
| Release version | Command history |
|---|---|
| 08.0.01 | This command was introduced for IPv6 VRRPv3 sessions running on FastIron device images. |
| 08.0.10b | This command was modified for IPv4 VRRPv3 sessions running on FastIron device images. |