ipv6 policy route-map

Enables IPv6 policy-based routing (PBR).
Syntax
ipv6 policy route-map route-map-name
no ipv6 policy route-map route-map-name
Command Default

PBR is not enabled.

Parameters
route-map-name
Specifies the name of the route map.
Modes

Global configuration mode

Interface configuration mode

Virtual interface configuration mode

Usage Guidelines

This command can be used to enable IPv6 PBR globally on all interfaces or on a specific interface.

The no form of the command disables IPv6 PBR.

Examples

The following example configures a route-map named test-route and enables IPv6 PBR globally. 

device# configure terminal
device(config)# ipv6 access-list acl8 permit 2001:DB8:12d:1300::/64
device(config)# route-map test-route permit acl8
device(config-routemap test-route)# match ipv6 address acl8
device(config-routemap test-route)# set ipv6 next-hop 2001:DB8:12d:1300:1
device(config-routemap test-route)# exit
device(config)# ipv6 policy route-map test-route

The following example configures a route-map named test-route and enables IPv6 PBR on Ethernet interface 1/1/1. 

device# configure terminal
device(config)# ipv6 access-list acl8 permit 2001:DB8:12d:1300::/64
device(config)# route-map test-route permit acl8
device(config-routemap test-route)# match ipv6 address acl8
device(config-routemap test-route)# set ipv6 next-hop 2001:DB8:12d:1300:1
device(config-routemap test-route)# exit
device(config)# interface ethernet 1/1/1
device(config-if-e1000-1/1/1)# ipv6 policy route-map map1
History
Release version Command history
08.0.70 This command was introduced.
Parent topic: Commands I