ipv6 mroute next-hop-enable-default
ipv6 mroute[vrfvrf-name] next-hop-enable-defaultno ipv6 mroute[vrfvrf-name] next-hop-enable-defaultIPv6 multicast static routes are not resolved using the default multicast static route.
Global configuration mode
VRF configuration mode
Before configuring an IPv6 multicast static route, you must enable the forwarding
of IPv6 traffic on the Layer 3 switch using the
ipv6 unicast-routing command and must enable IPv6 on at least one interface by configuring an IPv6 address
or explicitly enabling IPv6 on that interface.
The no form of the command
disables IPv6 static route next-hop resolution through the default route. If a
VRF
is configured, the no form of the command removes the static IPv6 route configuration
from the VRF.
The following example configures static routing next-hop recursion to three levels (the default). It configures the network default static route and allows it to resolve other static routes.
device# configure terminal device(config)# ipv6 mroute next-hop-recursion device(config)# ipv6 mroute 0.0.0.0 0.0.0.0 xxx.xxx.xxx.xxx device(config)# ipv6 mroute next-hop-enable-default
The following example enables the VRF named vpn1 to resolve an IPv6 multicast static route through the default IPv6 multicast static route, after configuring IPv6 on the device, setting a route descriptor for the VPN, and specifying IPv6 addressing be used on the VPN.
device# configure terminal device(config)# ipv6 unicast-routing device(config)# vrf vpn1 device (config-vrf-vpn1)# rd 100:200 device (config-vrf-vpn1)# address-family ipv6 device(config-vrf)# ipv6 mroute next-hop-enable-default
| Release version | Command history |
|---|---|
| 08.0.10a | This command was introduced. |