`distribute-list prefix-list`(OSPFv3)

Applies a prefix list to OSPF for IPv6 routing updates. Only routes permitted by the prefix-list can go into the routing table.

Syntax

distribute-list prefix-list list-name in [ ethernet unit/slot/port | lag lag-id | loopback number | tunnel number | ve virtual port number ]

no distribute-list prefix-list

Command Default

Prefix lists are not applied to OSPFv3 for IPv6 routing updates.

Parameters

list-name: Name of a prefix-list. The list defines which OSPFv3 networks are to be accepted in incoming routing updates.
in: Applies the prefix list to incoming routing updates on the specified interface.
ethernet unit/slot/port: Specifies an Ethernet interface.
lag lag-id: Specifies a LAG virtual interface.
loopback number: Specifies a loopback interface and port number.
tunnel number: Specifies a tunnel.
ve virtual port number: Specifies a virtual Ethernet (VE) interface.

Modes

OSPFv3 router configuration mode

OSPFv3 VRF router configuration mode

Usage Guidelines

The no form of the command removes the prefix list.

Examples

The following example configures a distribution list that applies the filterOspfRoutes prefix list globally.

device# configure terminal
device(config)# ipv6 router ospf
device(config-ospf6-router)# distribute-list prefix-list filterOspfRoutes in

History

Release version	Command history
08.0.61	This command was modified to add lag lag-id options.

distribute-list prefix-list (OSPFv3)