set next-hop-ip-tunnel
Configures an IPsec or GRE tunnel interface as the next hop of a PBR route map.
Command Default
The next hop is not set to a tunnel interface.
Parameters
Modes
Route map configuration mode
Usage Guidelines
When PBR is used to map IP traffic into a GRE tunnel or IPsec tunnel, the VRF of the tunnel interface is considered as the egress VRF interface.
The
no form of the command removes the tunnel interface as the PBR next hop.
Examples
The following example configures tunnel interface 1 as the PBR next hop.
device# interface tunnel 1 device(config-tnif-1)# vrf forwarding blue device(config-tnif-1)# tunnel source ethernet 1/1/1 device(config-tnif-1)# tunnel destination 10.2.2.1 device(config-tnif-1)# tunnel mode ipsec ipv4 device(config-tnif-1)# tunnel protection ipsec profile prof-blue device(config-tnif-1)# ip address 10.4.4.4/24 device(config-tnif-1)# exit device(config)# ip access-list standard 99 device(config-std-ipacl-99)# permit 10.157.23.0 0.0.0.255 device(config-std-ipacl-99)# exit device(config)# route-map test-route permit 99 device(config-routemap test-route)# match ip address 99 device(config-routemap test-route)# set next-hop-ip-tunnel 1 device(config-routemap test-route)# end device(config)# interface ethernet 1/1/3 device(config-if-e1000-1/1/3)# vrf forwarding blue device(config-if-e1000-1/1/3)# ip policy route-map test-route device(config-if-e1000-1/1/3)# end
History
| Release version | Command history |
|---|---|
| 08.0.50 | This command was introduced. |