hitless-failover enable
Enables hitless stacking failover and switchover. The standby controller is allowed
to take over the active role without reloading the stack when failover occurs.
Command Default
Hitless stacking failover is enabled. In earlier releases, failover and switchover were disabled by default.
Modes
Global configuration mode
Usage Guidelines
Use the
no form of the command to disable hitless stacking failover. The change takes effect
immediately.
The
hitless-failover enable and
no hitless-failover enable commands must be executed from the active stack controller.
You must assign a stack mac address to the device using the
stack mac address command before you can execute the
hitless-failover enable command.
History
| Release version | Command history |
|---|---|
| 08.0.00a | This command was introduced. |
| 08.0.20 | Hitless failover is enabled by default. |