webpage logo

Customizes the logo that appears on all Web Authentication pages and its placement.
Syntax
webpage logo { copy tftp { ipv4-address | ipv6-address } file-name | align { left | center | right } }
no webpage logo { copy tftp { ipv4-address | ipv6-address } file-name | align { left | center | right } }
Command Default

By default, the logo is left-aligned at the top of the page.

Parameters
copy tftp
Copies an image from the TFTP server to the switch.
ipv4-address
Specifies the IPv4 address of the TFTP server.
ipv6-address
Specifies the IPv6 address of the TFTP server.
file-name
Specifies the name of the file that must be copied from the TFTP server to the switch.
align
Configures the placement of the logo on the Web Authentication pages.
left
Aligns the logo to the left at the top of the page.
right
Aligns the logo to the right at the top of the page.
center
Aligns the logo to the center at the top of the page.
Modes

Web Authentication configuration mode

Usage Guidelines

To customize the banner image, use TFTP to upload an image file from a TFTP server to the FastIron switch. The image file can be in the jpg, bmp, or gif format, and its file size must be 64 KB or less. When you upload a new image file, it willl overwrite the existing image file.

The no form of the command deletes the logo from all Web Authentication pages and removes it from flash memory.

Note: The webpage logo command downloads the image file and stores it in the device flash memory. Therefore, it is not necessary to follow this command with a write memory command.
Examples

The following example shows how to replace the existing logo with a new one. 

device(config)# vlan 10
device(config-vlan-10)# webauth
device(config-vlan-10-webauth)# webpage logo copy tftp 10.10.5.1 ruckuslogo.gif

The following example shows how to right-justify the log at the top of the page. 

device(config)# vlan 10
device(config-vlan-10)# webauth
device(config-vlan-10-webauth)# webpage logo align right
Parent topic: Commands Si - Z