fdp advertise

Configures the IP management address to advertise for Foundry Discovery Protocol (FDP) neighbors.
Syntax
fdp advertise { ipv4 | ipv6 }
no fdp advertise { ipv4 | ipv6 }
Command Default

When FDP is enabled, by default, the device advertises one IPv4 address and one IPv6 address to its FDP neighbors.

Parameters
ipv4
Advertises only the IPv4 management address.
ipv6
Advertises only the IPv6 management address.
Modes

Interface configuration mode

Usage Guidelines

The no form of the command sets the device to advertis one IPv4 address and one IPv6 address to its FDP neighbors.

When FDP is enabled, by default, the device advertises one IPv4 address and one IPv6 address to its FDP neighbors. If desired, you can configure the device to advertise only the IPv4 management address or only the IPv6 management address. You can set the configuration globally on a Layer 2 switch or at the interface level on a Layer 3 switch.

Examples

The following example configures the device to advertise only the IPv6 management address. 

device(config)# interface ethernet 1/1/1
device(config-if-e1000-1/1/1)# fdp advertise ipv6
Parent topic: Commands D through H