logging cli-command
Logging of CLI commands is not enabled.
Global configuration mode
If the
logging cli-command command is configured, all the CLI commands executed by the user are logged in the
system log and are displayed in the
show logging
command output.
If the logging enable
rfc5424 command is present in the running configuration, the
logging cli-command feature is not supported.
The
no form of the command disables the logging of CLI commands from each user session into
the system log.
The following example enables the logging of CLI commands on the device.
device(config)# logging cli-command
The following example shows the system log records which are displayed in the
show logging command output. The system log contains the valid commands that are executed by the
user.
device (config)# show logging Syslog logging: enabled (0 messages dropped, 0 flushes, 5 overruns) Buffer logging: level ACDMEINW, 50 messages logged level code: A=alert C=critical D=debugging M=emergency E=error I=informational N=notification W=warning Dynamic Log Buffer (50 lines): 8d02h28m43s:I:CLI CMD: "ip route 0.0.0.0 0.0.0.0 10.20.64.1" by un-authenticated user from console 8d02h28m24s:I:System: Interface ethernet 1/1/1, state up 8d02h28m22s:I:CLI CMD: "enable" by un-authenticated user from console 8d02h28m22s:I:PORT: 1/1/1 enabled by un-authenticated user from console session 8d02h28m19s:I:CLI CMD: "disable" by un-authenticated user from console 8d02h28m19s:I:PORT: 1/1/1 disabled by un-authenticated user from console session 8d02h28m16s:I:CLI CMD: "interface ethernet 1/1/1" by un-authenticated user from console