prune-wait
Configures the time a PIM device waits before stopping traffic to neighbor devices
that do not want the traffic.
Command Default
The prune wait time is 3 seconds.
Parameters
Modes
PIM router configuration mode
Usage Guidelines
A smaller prune wait value reduces flooding of unwanted traffic. A prune wait value of 0 causes the PIM device to stop traffic immediately upon receiving a prune message.
If there are two or more neighbors on the physical port, you should not configure
the
prune-wait command because one neighbor may send a prune message while the other sends a join
message at the same time, or within less than 3 seconds.
The
no form of this command restores the default prune wait time of 3 seconds.