unit-name (Stacking)

Applies a name to a stack member.
Syntax
unit-name name_string
no unit-name name_string
Command Default

By default, units are identified by an ID number.

Parameters
name_string
Specifies the name of a stack unit. A unit name can be up to 63 characters long. A unit name must start with an alpha character and must not contain spaces.
Modes

Stack unit configuration sub-mode

Usage Guidelines

The no form of the command removes the unit name.

Examples

The following example applies names to the members of a three-unit stack, based on the building they support. 

device# configure terminal
device(config)# stack unit 1
device(config-unit-1)# unit-name building1
device(config-unit-1)# stack unit 2
device(config-unit-2)# unit-name building2
device(config-unit-2)# stack unit 3          
device(config-unit-3)# unit-name building3
device(config-unit-3)# end
device# write memory

Automatic copy to member units:  2  3
Flash Memory Write (8192 bytes per dot) 
.
Copy Done.
History
Release version Command history
08.0.90 This command was introduced.
Parent topic: Commands Si - Z