mstp edge-port-auto-detect
Automatically sets a port as an operational edge port.
Command Default
Ports are not automatically set as edge ports.
Modes
Global configuration mode
Usage Guidelines
You can configure a Layer 3 switch to automatically set a port as an operational edge port if the port does not receive any BPDUs from the time of link-up. If the port receives a BPDU later, the port is automatically reset to become an operational non-edge port.
Note: After configuring, it takes the port about three seconds longer to come to the enable
state.
The
no form of the command resets the port as a non-operational edge port.