zero-touch-ports
By default, ports are not used for PE discovery.
CB configuration mode
The
no form of the command disables zero-touch and spx-interactive probes on the specified
ports and makes them available for other uses.
Only CB ports can be configured as zero-touch ports.
Port ranges for zero-touch ports are independent from SPX port or LAG ranges. Changing one range does not affect the other.
Ports designated as zero-touch ports are used only to discover new PE candidates. They do not modify existing SPX ports or LAGs. For example, if a user connects a new link between the CB and an existing PE unit, the new link is not discovered. The user must manually add or remove a port to or from an existing SPX link or SPX LAG.
RUCKUS recommends that
zero-touch-ports designation be removed once all candidate PEs have been discovered. Once the designation
is removed, the ports can be configured for other purposes.
The following example designates a range of ports from 1/1/10 through 1/1/20 as zero-touch ports.
device# configure terminal device(config)# spx cb-configure device(config-spx-cb)# zero-touch-ports 1/1/10 to 1/1/20
The following example designates three independent ports (2/1/5, 2/1/7, and 3/1/9) as well as a range of ports (3/1/2 to 3/1/5) as zero-touch ports.
device# configure terminal device(config)# spx cb-configure device(config-spx-cb)# zero-touch-ports 2/1/5 2/1/7 3/1/2 to 3/1/5 3/1/9
| Release version | Command history |
|---|---|
| 08.0.50 | This command was introduced. |