zero-touch-enable

Allows the CB in a Campus Fabric (SPX) domain to discover PE candidates and convert them to active PE units.
Syntax
zero-touch-enable
no zero-touch-enable
Command Default

Disabled by default.

Modes

CB configuration sub-mode

Usage Guidelines

The command should be disabled if the user does not intend to discover new units in the domain.

Ruckus recommends removing zero-touch-enable configuration after all PEs are added.

The command cannot discover existing PE or provisional PE units.

You cannot use the spx interactive-setup or the zero-touch-enable command from a device running FastIron release 08.0.90 or later to discover PE candidates running a pre-08.0.90 release, due to a difference in message types beginning with the FastIron 08.0.90 release. Be sure to load the same FastIron 08.0.90 or later image to PE candidates before executing either command.

The no form of the command disables zero-touch functions.

Related commands:

  • zero-touch-ports
  • spx interactive-setup
  • spx zero-touch-deny

Examples

The following example enables the zero-touch utility, and also removes spx zero-touch-deny configuration, if present. 

device# configure terminal
device(config)# spx cb-configure
device(config-spx-cb)# zero-touch-enable
History
Release version Command history
08.0.50 This command was introduced.
Parent topic: Commands Si - Z