`tunnel vrf`

Configures the base VRF for an IPsec virtual tunnel interface (VTI).

Syntax

tunnel vrf name

no tunnel vrf name

Command Default

The default VRF is the base VRF for the IPsec VTI.

Parameters

Modes

Tunnel interface configuration mode

Usage Guidelines

Configuration of a base VRF is only supported on IPsec tunnel interfaces. The mode of the VTI must be set to ipsec before executing this command.

ICX 7150 devices do not support tunnels.

The no form of the command removes the base VRF configuration for the VTI.

Examples

The following example shows how to configure a VRF named blue as the base VRF for an IPsec tunnel identified as 1.

device(config)# interface tunnel 1
device(config-tnif-1)# tunnel mode ipsec ipv4
device(config-tnif-1)# tunnel vrf blue

History

Release version	Command history
08.0.41	This command was introduced.

tunnel vrf