`tunnel tos`

Configures the Type of Service (ToS) value for an IPsec virtual tunnel interface (VTI).

Syntax

tunnel tos tos

no tunnel tos tos

Command Default

The Type of Service is not configured for the IPsec VTI.

Parameters

tos: Specifies the Type of Service (ToS) value. The range is from 0 through 255.

Modes

Tunnel interface configuration mode

Usage Guidelines

When ToS is not configured for an IPsec VTI, the ToS value that is configured on the inner IP header is copied to the outer IP header.

ToS configuration is only supported on IPsec tunnel interfaces. The mode of the VTI must be set to ipsec before executing this command.

ICX 7150 devices do not support tunnels.

The no form of the command removes the ToS configuration on the VTI.

Examples

The following example shows how to configure a ToS value of 3 for an IPsec tunnel identified as 1.

device(config)# interface tunnel 1
device(config-tnif-1)# tunnel mode ipsec ipv4
device(config-tnif-1)# tunnel tos 3

History

Release version	Command history
08.0.41	This command was introduced.

tunnel tos