tunnel protection ipsec profile

Configures an IPsec profile for an IPsec virtual tunnel interface (VTI).
Syntax
tunnel protection ipsec profileipsec-profile-name
no tunnel protection ipsec profileipsec-profile-name
Command Default

An IPsec profile is not configured for the VTI.

Parameters
ipsec-profile-name
Specifies the name of the IPsec profile to secure packets that go out on this interface.
Modes

Interface configuration mode

Usage Guidelines

Before executing this command, the tunnel mode must be set to ipsec by using the tunnel mode ipsec command.

IPsec is supported only on ICX 7450 devices.

The no form of the command removes the IPsec profile configuration.

Examples

The following example shows how to configure an IPsec profile named prof_blue on a VTI with the tunnel ID 1 for an IPsec IPv4 tunnel. 

device# configure terminal
device (config)# interface tunnel 1
device(config-tnif-1)# tunnel mode ipsec ipv4
device(config-tnif-1)# tunnel protection ipsec profile prof_blue
History
Release version Command history
08.0.41 This command was introduced.
Parent topic: Commands Si - Z