sz disable
SmartZone IP addresses are not configured on the switch, which means the switch will attempt to initiate a connection with SmartZone using the SmartZone IP addresses provided via DHCP Option 43.
Global configuration
Use the no form of the
sz disable command to reenable SmartZone management of the device after it has been disabled.
Beginning with SmartZone release 5.0, SmartZone can be used to monitor and manage
ICX switches. An ICX switch identifies SmartZone and initiates a connection based
on the SmartZone IP addresses configured on the switch or discovered through DHCP
Option 43. When SmartZone management is disabled using the
sz disable command, the ICX switch will not initiate a connection with SmartZone, even if SmartZone
IP addresses are available.
Both "active" and "passive" SmartZone IP addresses can be configured on the ICX switch. Active IP addresses are given the highest priority; passive IP addresses are lowest priority and are provided for redundancy. The ICX switch will attempt to connect to SmartZone by sending a query to SmartZone IP addresses in the following order:
- SmartZone IP addresses configured on the ICX switch using the
sz activecommand - SmartZone IP addresses received through DHCP Option 43
- Backup SmartZone IP addresses configured on the ICX switch using the
sz passivecommand
The switch connects to SmartZone using a reverse SSH tunnel.
| Release version | Command history |
|---|---|
| 08.0.80 | This command was introduced. |