system-max max-ecmp

Configures the maximum limit of ECMP paths at the system level.
Syntax
system-max max-ecmp [ num ]
no system-max max-ecmp [ num ]
Command Default

The default value is 8.

Parameters
num
Specifies the maximum number of ECMP paths and can be from 8 through 32.
Modes

Global configuration mode

Usage Guidelines

The system-max max-ecmp command is supported only on the RUCKUS ICX 7750.

If the maximum number of ECMP paths is not configured at the system level, by default, you can configure the maximum number of IP load sharing paths to a value from 2 through 8.

The configuration of the maximum number of IP load sharing paths to a value more than 8 is determined by the maximum number of ECMP paths configured at the system level using the system-max max-ecmp command.

You cannot configure the maximum number of IP load sharing paths higher than the value defined at the system level.

You cannot configure the maximum number of ECMP paths at the system level to a value less than the configured IP load sharing value.

You must save the configuration and reload the device for the maximum ECMP value change to take effect.

The no form of the command removes the maximum number of ECMP paths defined at the system level.

Examples

The following example defines the maximum number of ECMP paths that can be configured in the system as 20. 

device(config)# system-max max-ecmp 20
device(config)# write memory
device(config)# exit
device# reload
History
Release version Command history
08.0.30 This command was introduced.
Parent topic: Commands Si - Z