spx suggested-id
The provisional PE does not suggest an ID by default.
Provisional-PE configuration mode
PE configuration mode
The command is available only on the ICX 7450, and only after the
spx pe-enable command has been entered. That is, the command is available only on a PE or a provisional
PE unit; it is not available from the control bridge (CB).
The suggested ID does not necessarily become the PE ID. Reserved configuration on the CB that matches the new PE unit takes precedence. Furthermore, if the ID is already assigned, it is not reassigned.
All SPX configuration created on the provisional PE must be saved with the
write-memory command, followed by the
reload command to take effect.
The following example suggests that the PE being configured be given the PE ID 20 when it joins a CB. Locally, the provisional PE or PE always refers to itself as SPX unit 1.
device# configure terminal device(config)# spx pe-enable Enter provisional PE mode. CLI is limited to spx unit 1. After finishing all configuration, please "write memory" and reload this unit to be a PE. [Provisional-PE]device(config)# spx suggested-id 20
| Release version | Command history |
|---|---|
| 08.0.40 | This command was introduced. |