spx allow-pe-movement
By default, a PE ID may change when a PE unit is moved.
Global configuration mode
The
no form of the command disables the feature.
The existing PE ID is used but the
pe-id
cb-port
id1 id2 configuration typically used in PE ID assignment is ignored when
allow-pe-movement is configured.
All port configuration in the PE still applies.
When you move a PE unit to a new port with
spx allow-pe-movement configured, the system detaches the port, and protocols register a "port down" event.
When the PE joins with the same number on a new SPX port or LAG, the unit is treated
as a new PE, and protocols initialize normally.
RUCKUS recommends removing
spx allow-pe-movement configuration once you are finished moving PE units. After removing the configuration,
execute the
write memory command.
| Release version | Command history |
|---|---|
| 08.0.50 | This command was introduced. |