show startup-config (SPX)
PE mode
Provisional-PE mode
This command is available only on an ICX 7450 unit configured as an 802.1br Provisional-PE
or PE unit with the
spx pe-enable command. The
show startup-config
command shows the startup configuration that would be used by this unit if it were
operating in regular mode as a switch or router.
In PE or Provisional-PE mode, the
show configuration command shows the configuration in the PE startup file for this unit. In regular
switch or router mode, use the
show running-config command to show the currently running switch or router configuration.
The following example displays the configuration this active PE would have if it returned to regular mode.
[PE]local-id@device# show startup-config *** display startup configuration used in switch/router (not PE) *** ! Startup-config data location is flash memory ! Startup configuration: ! ver 08.0.40b739T213 ! stack unit 1 module 1 icx7450-24-port-management-module module 2 icx7400-xgc-4port-40g-module module 3 icx7400-qsfp-1port-40g-module module 4 icx7400-qsfp-1port-40g-module ! ! interface management 1 ip address 10.20.226.194 255.255.255.0 ! interface ethernet 1/2/1 speed-duplex 10G-full ! interface ethernet 1/2/2 speed-duplex 10G-full ! interface ethernet 1/2/3 speed-duplex 10G-full ! interface ethernet 1/2/4 speed-duplex 10G-full ! ! End
| Release version | Command history |
|---|---|
| 08.0.40 | This command was introduced. |