show configuration (SPX)

Shows the startup configuration in regular switch or router mode, or the PE startup configuration in Provisional-PE or PE mode.
Syntax
show configuration
Modes

Device mode

PE mode

Provisional-PE mode

Usage Guidelines

In regular switch or router mode, the show configuration command shows the saved startup configuration.

In PE or Provisional-PE mode, the show configuration command shows the configuration in the PE startup file for this unit. To view the configuration that the unit would have in regular mode (as a switch or router), use the show startup-config command.

The show configuration command displays the following information in Provisional-PE and PE mode:

Output field Description
ver Software version loaded to this unit.
spx-enable The unit has been enabled to act as an SPX PE unit.
spx unit x SPX unit number. Locally, the SPX number will always be 1 for the unit.
module x Module number and type installed for this SPX unit.
spx-lag SPX LAG configuration for this unit (if any).
spx-port SPX port configuration for this unit (if any).
Examples

The following example shows the saved startup configuration for a provisional PE that has been enabled with the spx pe-enable command. 

[Provisional-PE]device# show configuration
Configuration in PE startup file:
!
ver 08.0.40b1T213
!
spx pe-enable
spx unit 1
  module 1 icx7450-48f-sf-port-management-module
  module 2 icx7400-xgf-4port-40g-module
  module 4 icx7400-qsfp-1port-40g-module
  spx-lag 1/2/1 to 1/2/2
  spx-port 1/2/4

The following example shows the startup configuration for the active PE unit. Jumbo mode has been enabled on the CB. 

[PE]local-id@device# show configuration
Configuration in PE startup file:
!
ver 08.0.40b728T213
!
spx pe-enable
spx unit 1
  module 1 icx7450-48p-poe-management-module
  module 2 icx7400-xgf-4port-40g-module
  module 3 icx7400-qsfp-1port-40g-module
  module 4 icx7400-qsfp-1port-40g-module
  spx-lag 1/1/1 to 1/1/3
  spx-port 1/2/4
!
jumbo 
!
[PE]local-id@device#

The following example shows command output when the PE configuration has not been saved with the write memory command. 

[Provisional-PE]device(config-spx-unit-1)# show configuration
PE startup file does not exist.
[Provisional-PE]device(config-spx-unit-1)# end
History
Release version Command history
08.0.40 This command was introduced.
Parent topic: Show Commands