Port General Settings

Configure the port general settings for all RUCKUS Edge devices in this cluster. Any ports that have been added to a LAG in the previous section of this wizard will be grayed out in this section.
  1. Within each port sub-tab, configure the following details:
    • Description - Enter a short description to identify the port.
    • Port Type - Select the type of port from the drop-down list.
      Note: A maximum of two WAN interfaces are allowed.

    Port Type Configuration

    Port Type Use port as IP Settings
    WAN Not applicable: The WAN port type does not support access and core separation. WAN port type ports perform both roles at the same time and the following rules apply:
    • If any port is selected as WAN type, Access/Core separation options are not available to any port.
    • If either Port1 or Port2 are marked as Access port or Core port, WAN type is not available to any port.
    • Choose IP Assignment
      • DHCP: Automatically provides IP address with the host IP address.
      • Static/Manual: Enter the following:
        • IP Address
        • Subnet Mask
        • Gateway
    • Click the Use NAT Service toggle to enable the option and enter the following NAT IP Addresses Range:
      • Start
      • End
    LAN Applicable to SD-LAN services only. For more information refer to SD-LAN.

    Select the required checkboxes:

    • Core port
    • Access port
    Note: Only one port can be selected as Access and only one port can be selected as Core at a time, making these options unavailable to any other ports.

    Hover over the icon next to Access port and click See the compatibility requirements to check the Compatibility Requirement.

    • IP Address
    • Subnet Mask
    Cluster Not Applicable Choose IP Assignment
    • DHCP: Automatically provides IP address with the host IP address.
    • Static/Manual: Enter the following:
      • IP Address
      • Subnet Mask
    Note: Change the Port Type while configuring the other ports.
  2. Click Next.
    If configuring a single-node cluster, the Dual WAN Settings page is displayed. If configuring a two-node cluster, the Sub-interface Settings page is displayed.