Features on RUCKUS Edge
SD-LAN Service support features:
The following RUCKUS Edge features enable SD-LAN service on the Edge:
Active–Active Edge Clusters
A four‑node Active–Active cluster runs all nodes simultaneously and distributes traffic and services across them. Each node shares the AP load, and failover occurs between active nodes. This design increases throughput, resiliency, and service continuity required for large deployments with Edge as data place.
Core–Access Separation
RUCKUS Edge separates the core‑facing network from the access‑facing side.
-
Core ports connect to the core, DMZ or L2GRE uplink and carry forwarded or bridged traffic in SD-LAN service
-
Access covers the AP side, where VXLAN tunnels terminate. IP address of Edge’s Access port is used by the AP as tunnel remote end point IP
Core and Access ports could be physical ports, LAGs, or sub-interfaces on a physical port or LAG.
This separation keeps traffic roles, policies, and security boundaries clear and reduces design complexity.
LAG Support for Core or Access Ports
RUCKUS Edge supports Link Aggregation Groups (LAG) using LACP. Multiple physical ports can operate as one logical interface to increase capacity and provide link redundancy.
Along with single interfaces, LAG interfaces can also be configured as CORE or Access ports.
NAT-T Support
One or more NAT servers can exist between AP and Edge device. NAT Traversal (NAT‑T) allows a VxLAN‑GPE tunnel to be successfully established and maintained between an AP and a RUCKUS Edge device even when APs are behind a NAT server. NAT-T does not work on tunnels between Edge devices, such as Data Center (DC) to DMZ.
PIN Service Support Features
The following RUCKUS Edge features enable PIN service on the Edge:
A two‑node Active–Standby cluster runs one active and one standby node. The active node processes traffic and services, while the standby node takes over when the active node fails. This model provides straightforward high availability with simpler deployment, though without workload distribution.
RUCKUS Edge supports Link Aggregation Groups (LAG) using LACP. Multiple physical ports can operate as one logical interface to increase capacity and provide link redundancy.
LAGs can be configured as:
– LAN links (for example: toward the core network)
– WAN links (for example: toward the internet or upstream router)
Traffic is load‑balanced across member ports using standard hashing of source/destination IP and Layer‑4 ports.