SD-LAN Workflow

This workflow describes the sequential steps required to configure SD‑LAN services on RUCKUS One using RUCKUS Edge. The workflow ensures that all dependent components are configured in the correct order to enable a stable, scalable, and resilient SD‑LAN deployment.

The following step-by-step configurations are required on RUCKUS One to complete the SD‑LAN service.

  1. Onboard Edge Cluster in Active-Active mode: Even when there is only one Edge node in the cluster, it should be configured in Active-Active mode. Within the Cluster:
    • Core and Access port configuration: In a single-leg deployment, the same interface can be configured as both core and access port, whereas in a two-leg deployment these ports are configured on different interfaces. Untagged Ethernet or LAG interfaces or IEEE 802.1Q sub-interfaces on Ethernet or LAG ports can be configured as core or access ports.
    • Cluster Interface port configuration: The Cluster Interface is crucial for enabling clustering in RUCKUS Edge. A specific interface can be selected as cluster interface on each Edge node of the cluster for communication between Edge nodes of the cluster. This interface facilitates cluster formation, the exchange of cluster information, and node health maintenance. For each node in the cluster, this interface should be connected to the same Layer 2 network, separate from the LAN network. The cluster interfaces for all Edge nodes in a cluster must be the same interface type, either a physical port or a LAG.
    • RUCKUS Edge Fallback Schedule Configuration: The RUCKUS Edge Fallback feature allows an AP to reconnect to the Primary Edge device according to the user-configured schedule. For feature details, refer to RUCKUS Edge Fallback.
    • Configure the Load Distribution method as either Random or Per AP Group to ensure AP load distribution across the Edge devices.
  2. Configure a Tunnel profile for AP-DC tunnels, DC-DMZ, or L2GRE.
  3. When tunnel encryption is required, an IPSec profile must be configured.
  4. Configure the SD-LAN service.