Creating an IPSec Profile (MSP Tenant)

IPSec Profiles define the IKE/ESP parameters, pre‑shared key, encryption proposals, and authentication methods used when Tunnel Encryption is enabled for VxLAN‑GPE tunnels. Under Edge Delegation, these profiles must be created and managed exclusively by the MSP tenant.
  1. Method 1 — Creating an IPSec Profile from the Templates Menu
    1. From the MSP Account or portal, go to: Templates > Add Template > Services > IPSec.
    2. On the Add IPSec Template page, configure the following:
      • Profile Name: Enter a name for the IPSec Profile.
      • Pre‑Shared Key: Specify the pre-shared key.
      • IKE Algorithm Combination: Select the required IKE proposal from the drop‑down list.
    3. Click Add to create the IPSec Profile Template.
  2. Method 2 — Creating an IPSec Profile from Within the Tunnel Profile Template
    1. On the Add Tunnel Profile Template page, toggle Tunnel Encryption to ON.
    2. In the Tunnel Encryption section, click Add.
    3. The Add IPSec Template page opens.
    4. Configure the following:
      • Profile Name: Enter a name for the IPSec Profile.
      • Pre‑Shared Key: Specify the pre-shared key.
      • IKE Algorithm Combination: Select the required IKE proposal from the drop‑down list.
    5. Click Add. The newly created IPSec Profile Template will now be available for selection within the Tunnel Profile Template.
    Note: For Edge Delegation:
    • All Tunnel Profile and IPSec Profile configurations must be created and owned by the MSP tenant.
    • EC tenants receive read‑only visibility of these templates once applied.
    • Any updates—such as modifying IPSec parameters, toggling encryption, or renaming templates—must be made at the MSP Template level and synced to all EC tenants.
    • When Tunnel Encryption is toggled ON or OFF, all associated AP tunnels will temporarily go down and then re‑establish.
    • NAT‑T is automatically enabled when encryption is active and remains enabled even after encryption is disabled.