High Availability Active-Standby Deployment Model

High Availability supports the Active-Standby deployment model.

High Availability (HA) mode supports two-node cluster operation in the Active-Standby deployment model. The High Availability functionality in RUCKUS Edge is based on Virtual Router Redundancy Protocol (VRRP). VRRP allows multiple routers to form a virtual router group and provide redundancy for the default gateway of the network.

This Active-Standby mode uses VRRP to provide the Data Plane redundancy. The active node provides RUCKUS Edge services to APs while the standby node only monitors the active node. If the active node fails, the standby node switches to the active node role and starts providing the services.

Note: The member APs connected to the RUCKUS Edge device are unaware of the failover transition as they are connected to the RUCKUS Edge device using the VRRP IP Address (VIP).

Failure and Expected Behavior

In case of active node failure, the standby node takes ownership of the VRRP IP address and becomes the active node in the network. All the data traffic from the AP/Switch moves automatically to the new active node in the network.

LAN, Node and Cluster Link Failure and Expected Behavior

Failure Type Failure Behavior Failure Recovery Behavior
LAN Failure In this case, the standby node acts as the active node. If the network is divided, then it is normal to have two active nodes in the network. After the network failure or link failure is rectified, the cluster is back to Active-Standby mode for operation.
Node Failure In this case, the standby node takes over as the active node. After the active node is initialized, it rejoins the cluster as a standby node.
Cluster Link Failure In this case, the standby node stops all the services and expects the active node to connect.

In the described state, the standby node periodically transitions from the waiting for active node state to verify the Data Plane status.

If the Data Plane status is active, then the standby node changes the status to active.

If the Data Plane status is standby and the cluster link remains down, the standby node reverts back to the waiting for active state.

After the cluster link becomes active, the standby node rejoins the cluster, and the Data Plane is then enabled to participate in High Availability (HA).