Quarantine State

A power-on self-test (POST) failure causes the system to enter the quarantine state. In this state, only the CO, using the administrator account, can access the command-line interface (CLI) through the console to perform recovery operations. A limited set of CLI commands is available for system recovery.

When a power-on self-test (POST) fails, the system moves to the quarantine state. In the quarantine state, only the CO (admin) can log in to the command line interface (CLI) through console access, and recover the system by using the CLI commands for system recovery.

In the quarantine state, all communication towards external nodes is disabled, and network interfaces remain inactive. The output for the fips status command displays the current FIPS mode and the quarantine status, as shown below.

vSZ FIPS Quarantine Status

vDP FIPS Quarantine Status

To recover from the quarantine state, the CO must log in to the console and execute the fips disable command, and confirm the action by entering yes. This process cleans up the system and recovers the CLI functionality. The CO can then use the setup command to reconfigure the system.