AP Models that Support FIPS Mode

This section lists the RUCKUS Access Point models that are certified or compatible with FIPS 140-3 mode. These models meet the cryptographic requirements necessary for deployment in FIPS-compliant environments.

The following 802.11be APs are FIPS certified models supported in the 7.1.1.3 release.

802.11be (Wi-Fi 7) AP Models Supported on FIPS Mode

AP Models Hardware Part Number
R670-US Access Point 9F1-R670-US00
R670-WW Access Point 9F1-R670-WW00
R770-US Access Point 9F1-R770-US00
R770-WW Access Point 9F1-R770-WW00
T670-US Access Point 9F1-T670-US01
T670-WW Access Point 9F1-T670-WW00
T670sn Access Point 9F1-T6700US51

Note: 11ax APs can continue to provide service when vSZ is upgraded from 5.2.1.3 to 7.1.1.3 FIPS.

The following ESXi software models are supported in FIPS mode.

  • ESXi-6.7U1-10764712-A03 (VMware, Inc.)
  • ESXi-7.0.0U3 (VMware, Inc.)
  • ESXi-8.0U3-24022510 (VMware,Inc.)
Note: The peer node (server) selects the FIPS compliant ciphers while establishing a connection with the AP.
Attention: While the registration of components is done over a secure TLS channel, this part has not been claimed in the CC evaluation due to limited certificate verification capabilities during the registration. The TOE requires the use of a dedicated channel for the AP and vSZ-D to register with a Controller. The administrator must perform the registration of TOE components in a controlled environment in which there is a segregated network with only TOE components present. Further communication between AP/vSZ-D and (v)SZ is secured through the SSH connection.