IPsec Support for SmartZone Clustering

IPsec configuration for SmartZone clustering involves setting up secure communication channels between SmartZone nodes using IPsec tunnels.

Feature Overview

This functionality ensures that data exchanged within the cluster, such as control traffic and synchronization information, remains encrypted and protected from unauthorized access. The process typically includes configuring IKEv2 parameters, defining encryption protocols, and establishing Security Associations (SAs) to enable secure and efficient cluster communication.

To establish secure communication between two nodes, Transfer Layer Security (TLS) process is used to exchange sensitive information, such as keys and certificates, followed by creation of IPsec tunnel for ongoing encrypted communication.

Requirements

The following are the requirements for IPsec support in SmartZone clustering:

  1. SmartZone Cluster: Ensure all cluster nodes run compitable and supported versions of the SmartZone firmware.
  2. Supported Encryption Standards: Advanced Encryption Standard (AES) for encryption is supported.
  3. Certificates: All the nodes should have valid and non-expired certificates.

Considerations

The following are the keypoints for supporting IPsec in SmartZone clustering:

  1. Network Infrastructure: Minimal Latency between cluster nodes to avoid delays in synchronization.
  2. Supported Cipher Suite: Strong encryption algorithm such as AES-256-GCM is used for encryption and integrity.

Best Practices

The following are the recommended best practices for supporting IPsec in SmartZone clustering:

  • Make sure that during the joining process, the SmartZone prompts for necessary certificates.
  • All the certificates should authenticate the SmartZone with the network and establish secure communication between devices.
  • Ensure that the certificates are valid, check expiration dates and verify their authenticity with the issuing certificate authority (CA).

Prerequisites

The following are the pre-requisites for IPsec support in SmartZone clustering:

  1. The leader node must be operational and running the current image. The follower node must also run on the current image.
  2. Make sure that the network configuration on the follower node is fully completed.