General Information about Tamper-Evident Seals

The tamper-evident custom security labels are FIPS-certified for SmartZone and AP products. The following sections include photos showing locations where the seals must be applied by product type.

For all seal applications, ensure that the following instructions are observed:

  • All surfaces to which the seals will be applied must be clean and dry. Use alcohol to clean the surfaces. Do not use other solvents.

  • Do not cut, trim, punch, or otherwise alter the tamper-evident seal.

  • Do not use bare fingers to handle the labels. Slowly peel the packing from each seal, taking care not to touch the adhesive.

  • Use very firm pressure across the entire seal surface to ensure maximum adhesion.

  • Allow a minimum of 24 hours for the adhesive to cure. Tamper evidence may not be apparent until the adhesive cures.

When a tamper-evident seal is removed from the surface to which it has been applied, several tamper indications are apparent. The removed seal shows a checkerboard destruct pattern. The graphics printed within the seal are uniquely split between the removed seal and the residue left on the surface.