Troubleshooting the Installation

Review the following troubleshooting steps to determine the cause if you are unable to verify AP operation.

If the startup sequence does not work, verify that the network name (SSID) and security settings (if you enabled them) on the AP match the settings on your wireless device.

  • Disconnect the AP from the power source, wait five seconds, reconnect it, and then wait 60 seconds before attempting a reconnection.
  • Disconnect and reconnect the AP and the PC.
  • Replace the Ethernet cable with a new one if the relevant LAN port LED is not illuminated. (LEDs in each port light up during a successful connection.)

If all else fails, you can reset the AP to its factory defaults (and start over).

  1. Insert a straightened-out paper clip into the Reset button hole.
  2. Press and hold the Reset button for at least six (6) seconds.

You can now reconnect your computer directly to the AP (as described in Connect the AP to the Administrative Computer, and then start over with installation, using the default network settings.